Museum of the Broadcast Television Camera

Fairchild CCD Television Camera type "Cam2000"

Fairchild CCD Television Camera type "Cam2000"

The "CCAID" control unit with a short shielded 25 dee cable.

 

The control unit for the CCD2000C/CCD2100C camera subsystem is a 10 by 8-1/2 by 5 inch metallic enclosure which is designed for bench-top installation (Figure 3). The control unit provides operating bias voltages and timing signals to the camera, provides access connectors for the digital (TTL level) input and output signals of the subsystem, and contains the few operating function controls for the subsystem. The control unit power input is fuse protected. Line voltages of 115 or 230 Vac ± 10%,50-400 Hz may be used.
The principal circuitry within the control unit is contained on a single printed circuit board designed as a "timing logic card". The TTL hardware logic on this card includes horizontal and vertical counter chains which drive PROMs programmed for generation of CCD sensor and TV-sync timing signals. The counter chains, which can be driven by either an internal crystal controlled master oscillator or an external TTL-level master clock input signal, also develop numerical sequence binary-coded address data which identifies individual pixel outputs from the sensor in the camera. The control unit contains two card slots which are
pre-wired to accept the optional pixel-address buffer card and the sweep generator card described below. These cards will be installed in the control unit if ordered with a CD2000C or CCD2100C camera subsystem. The control unit panels support BNC connectors which
provide user access to the following system TTL output signals: Binary Video, Composite Blanking, Field (odd) Sync, Composite Sync, Video (Data Rate) Clock, Exposure Sync, Vertical Sweep and Horizontal Sweep. The control unit will accept, through BNC connectors, TTL waveforms for external Exposure Control and external Video Data Rate clock inputs. Panel mounted controls are Power Off/On, AGC Off/On, the Video Clock Internal/External select switch, and a potentiometer for 'adjustment of the Binary Video threshold voltage. A 25-pin D connector provides 1/0 connection to the camera cable and a 50-pin D connector provides user access for digital I/O signals.