
Marconi MkIB Television Camera
CCU type T-A 113302.
This is the Camera Control Unit (CCU) it has a picture monitor
and a smaller waveform monitor, the principal controls are on the front
panel with secondary controls under the top flap. (picture inset lower
right).
The rear connector panel is pictured upper right, it has the following
connections;
communications, drive pulses input, drive pulses loop out (this connector
has a 3 x 75ohm terminating plug in it), one video output, sync input,
the power supply connector, and the camera cable connector.
This CCU has
a non-original camera cable connector, the holes where the original connector
fitted can be seen in the photograph above. The correct connector used
one with 3 integral coaxial
sockets.